CAR AIR-CONDITIONING

At Stargen Auto Electrical we are determined to always keep our clients cool and comfortable behind the wheel. If you notice a lack of cooling in your car, swing by and let us assist you.

We vacuum and fill new oils with every regas.
We recover, regas all makes and models of vehicles and provide a diagnostic check on your climate control aircon to ensure you always remain cool.

Process

• Refrigerant recovery and recycling
• Release of Air Purge
• Release of Oil Drain
• Evacuation Sealing Vacuum
• Checking Vacuum
• Aircon Dye Injector
• Oil Recharge
• Refrigerant Charge

COMPRESSOR:

The Compressor transports the refrigerant at the required pressure through the air conditioning system. The refrigerant is a low pressure gas as it enters the Compressor from the Evaporator. The Compressor increases the refrigerant pressure and also its temperature so it becomes a high pressure gas which, in turn, helps the refrigerant condense more rapidly in the next component, which is the Condenser. The Compressor is mounted on the engine and is driven by a belt from the engine’s crankshaft pulley. The most common reasons for failure are lack of oil, pulley bearing wear, electromagnetic coil burn-out and lack of regular servicing.

CONDENSER:

The Condenser works in the opposite way to the Evaporator. The refrigerant gives up its heat generated by the Compressor by passing cold air across its fins and tubes by ram air or by an extra fan. The end result of this change is that the refrigerant is now a high pressure liquid and is forced out to the Receiver Drier through the liquid line. Because the Condenser is usually located at the front of the vehicle it can become damaged by debris or corroded by materials from the road. It can also fail because of weak spots in its construction and also lack of regular servicing.

FILTER DRIER:

Depending on the type of air conditioning system fitted, this item can be called a Receiver Drier or an Accumulator. (The Accumulator is fitted on the low pressure gas line of an air conditioning system between the Compressor and the Evaporator and is used in conjunction with an orifice tube). The Receiver Drier is fitted on the high pressure liquid line of an air conditioning system between the Condenser and Expansion Device. The Receiver Drier has two parts to it, the receiver and, of course, the drier. The receiver section holds the right amount of refrigerant required by the system to ensure correct operation and to supply a steady flow of liquid refrigerant to the Expansion Device. The drier section is responsible for removing moisture from the air conditioning system by means of a bag of desiccant which absorbs small quantities of moisture. This is a very important part of the air conditioning system and should be changed at least every two years or when the system is repaired. The most common reasons for failure is corrosion and desiccant deterioration which leads to severe system failure.

EXPANSION DEVICE:

The Expansion Device comes in many forms. It can be a brass internally or externally equalized valve, a block type valve or an orifice tube (the latter being part of an Accumulator type air conditioning system). Expansion Device’s have an inlet and an outlet which separates the high side of the system from the low side. A small restriction in the valve allows only a small amount of refrigerant to pass through it into the Evaporator, the amount of refrigerant passing through the valve depends on the Evaporator temperature. The most common reasons for failure are contamination, moisture and lack of regular servicing.

EVAPORATOR:

As soon as the liquid pressure drops, the refrigerant begins to boil (R134A refrigerant boils at approximately -26 degrees centigrade). As it continues to boil the Evaporator absorbs the heat passing over its tubes and fins and as a result the air is cooled. Remember that heat is being removed from the warm air and cold air is not being created. The compressor, on its suction side, removes the low pressure vapour from the Evaporator and the cycle starts all over again. The most common reasons for failure are corrosion, weak spots in construction and lack of regular servicing.

We are equipped to diagnose and test your Air Conditioning system for refrigerant leaks and other problems. More importantly –our diagnostic equipment allows us to refill your unit to the correct levels – which is critically important if you want to avoid damage to the Air Conditioning unit.

We will also make sure that, if required, your cabin air-filter is in good working order. This important component of your Air Conditioning system ensures polluted air is kept out of your cabin –and your lungs.

At Stargen Auto Electrical we have the right equipment – and skilled technicians – to get you back on the road – in comfort, in no time.

Contact us today to make an appointment – or just drop by for a fast, professional and affordable service!